Published

49 CFR 393.11 Lamp and Reflector Check: A Practical Pre-Trip Guide

When a lamp or reflector needs replacement on a commercial vehicle, the useful first question is not which bulb is brightest, but which item the vehicle is required to have. Under 49 CFR § 393.11, Table 1 specifies requirements for lamps, reflective devices and associated equipment by the type of commercial motor vehicle, and the diagrams in the section show where those items are positioned [1]. A practical check starts by matching the vehicle type to the table before buying or installing anything.

The vehicle’s manufacture date matters because the rule sets different baselines. Commercial motor vehicles manufactured on or after December 25, 1968 must, at a minimum, meet the applicable requirements of 49 CFR 571.108, FMVSS No. 108, in effect when the vehicle was built. Vehicles manufactured before that date must, at a minimum, meet the requirements of subpart B of part 393 in effect at the time of manufacture [1]. This is why an older vehicle and a newer vehicle can need different verification steps even when the visible lamp layout looks similar.

Build the checklist from the table’s columns, not from memory. Table 1 lists each item with quantity, color, location, position, and height above the road surface measured from the center of the lamp at curb weight [1]. For example, the table entry for headlamps calls for two white lamps at the front, at the same height and with an equal number at each side of the vertical center line as far apart as practicable, at not less than 559 mm and not more than 1,372 mm above the road. The front turn signal entry calls for two amber lamps at or near the front, one on each side of the vertical centerline at the same height, at not less than 381 mm and not more than 2,108 mm [1]. Recording the existing item, color, side and height gives a much better replacement brief than “driver-side front lamp.”

Larger trailers have an additional conspicuity item to check. Each trailer of 2,032 mm (80 inches) or more overall width, with a GVWR over 4,536 kg (10,000 pounds), manufactured on or after December 1, 1993, must be equipped with retroreflective sheeting, reflex reflectors, or a combination of both meeting FMVSS No. 108, except pole trailers and trailers designed exclusively for living or office use [1]. The rule also says the conspicuity system must be installed and located as specified in FMVSS No. 108 and have the required certification and markings [1]. A walk-around should therefore separate “a reflector is present” from “the required conspicuity system is present and marked.”

Do not treat color swaps as a harmless upgrade. Section 393.11 prohibits a commercial motor vehicle from being equipped with an amber stop lamp, a tail lamp, or another lamp optically combined with an amber stop lamp or tail lamp [1]. There is also a reflector exception for trailers equipped with conspicuity material meeting § 393.11(b): those trailers are not required to have the reflex reflectors listed in Table 1 if the material is placed where the table requires reflectors and meets the visibility requirements for reflex reflectors [1]. Those details belong in the checklist next to the lamp description.

A sensible pre-trip routine is to photograph each required lamp and reflector, note its color, side, quantity and mounting height, then compare the photo and the vehicle type against Table 1 before ordering a replacement. If you use the site’s beam angle and spot-size calculator for auxiliary lighting, treat the result as an estimate of light pattern, not as a substitute for the regulation’s required lamp and reflector layout [1]. The regulation text and Table 1 remain the checklist for what must be present and where; the calculator helps with aiming and coverage once the required items are confirmed [1].

Sources and dates checked

  1. 49 CFR § 393.11 - Lamps and reflective devices. (2026-11-19)

This article was created with AI assistance and checked by our automated editorial process.

General information; not a binding quote or individual investment, legal, engineering or medical advice.